Compact warmer that's perfect for those with limited counter space. - Accomodates 2 body and 2 face applicators - No time is wasted for new refills to heat - The compartment in the back of the unit allows two extra applicators to heat to 100° F (43° C), allowing a quicker heat up time when placed into the heater unit. - The five sided heater plates allow for even heating - Heater plates are curved over the top of the roller heads allowing any wax residue to simply melt back into the wax applicator, increasing efficiency and cleanliness
DIRECTIONS FOR USE Step 1: Insert plug of warming unit into receptacle Step 2: Remove caps from wax applicators and replace with roller, turning roller heads until they stop. Do not overturn the rollers. Step 3: Insert wax applicators into the warming unit with the roller facing the heat plate. This allows the roller to remain warm and allows for easier, cleaner application. Step 4: Place cloth strips or two additional wax applicators into the pocket on the rear compartment of the warming unit. Step 5: Turn the warming unit on by moving on/off switch, located on the left side of the housing, to the "on" position. Step 6: There are two variable thermostats, one on the upper left and one on the upper right side of the warming unit. The thermostat on the left side of the unit regulates heat for the medium (body) wax applicators, while the thermostat on the right side of tht unit regulates heat for the small (face) applicators. To begin, set both of the variable thermostats to the warmest position (one full turn clockwise). Step 7: Allow 20 to 30 minutes for the wax bottles to warm to an appropriate working temperature, then move the thermostats to the center position (indicated by the markings next to the thermostat dials). This is the approximate working temperature for the warming unit. Step 8: At this point, the wax will have reached a comfortable working temperature; however, wait an additional five minutes for the wax temperature to stabilize before applying wax. NOTE: The proper working temperature can be adjusted at any time by the operator to compensate for room temperature and voltage differences or for personal comfort.